Changes to Step #6
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] X axis preparation |
|---|---|
| [* 10] In this step we prepare the X axis to later assemble it on the Z axis. | |
| [* 5] If you are using the Bear X axis or Original Prusa MK2(S)/MK2.5(S) you need to unscrew ~2mm of the smooth rods screws. | |
| [* 9] If you still have the X carriage (or extruder) in place you must release the belt tension in X axis. | |
| [* 4] ***Bear extruder and X axis (BearExxa), BearMera of Bear X axis with Bondtech extruder:*** release tension using the belt tensioning screws. | |
| [* 7] ***Original Prusa MK3(S):*** remove the 2x top motor screw and release tension of the screw on the X motor arm. Then rotate the X motor. | |
| [* 7] ***Original Prusa MK2(S) or MK2.5(S):*** remove the 2x top motor screw and rotate the X motor. | |
| [* 9] Be careful, if you still have the X carriage (or the extruder) in place you will have to disassemble the Z motors to insert the X axis in the next step. |