Changes to Step #6

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] X axis preparation
-[* 10] In this step we prepare the X axis to later assemble it on the Z axis.
-[* 5] If you are using the Bear X axis or Original Prusa MK2(S)/MK2.5(S) X axis you need to unscrew a little the smooth rods screws (approx. 2mm).
-[* 9] If you still have the X carriage (or extruder) in place you must release the belt tension in X axis.
+[* 10] In this step we prepare the X axis for later assembly on the Z axis.
+[* 5] If you are using the Bear X axis or the Original Prusa MK2(S)/MK2.5(S) X axis, you will need to unscrew the smooth rod tensioning screws, as shown (by approx. 2mm).
+[* 9] If you still have the X carriage (or extruder) in place, you must ensure that the X axis belt is not under tension.
[* 4] ***Bear extruder and X axis (BearExxa), BearMera of Bear X axis with Bondtech extruder:*** release tension using the belt tensioning screws.
[* 7] ***Original Prusa MK3(S):*** remove the 2x top motor screws and release tension of the screw on top of the arm. Then rotate the X motor.
[* 7] ***Original Prusa MK2(S) or MK2.5(S):*** remove the 2x top motor screws and rotate the X motor.
[* 9] Be careful, if you still have the X carriage (or the extruder) in place you will have to disassemble the Z motors to insert the X axis in the next step.