Changes to Step #7
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 9] Be careful with this steps as you might damaged the lead screw nuts (black nuts on the X ends). |
|---|---|
| + | [* 7] Place the X axis on top of the Z lead screws. Carefully rotate by hand the Z lead screw to engage and move down the X axis. |
| + | [* 9] Be very careful, never force on the lead screw nuts or you might damage them |
| + | [* 9] Rotate the lead screws in synchronization. |
| + | [* 5] Continue to rotate the Z lead screws ***simultaneously*** until you can align the top X smooth rod with the bottom of top Z axis extrusion. |
| + | [* 9] Verify the X axis is parallel. |
| + | [* 8] ***Very gently*** slide the two Z smooth rods (320mm long) down to the Z motors. Make sure you could hear the Z smooth rods touching the motor surface indicating they are fully inserted. |
| + | [* 9] Verify the Z smooth rods are fully inserted (you can hear when they are touching the Z motors). |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added