Changes to Step #9
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Z tops installation |
|---|---|
| [* 8] Install the ''z_tops'' on top of the Z axis. T-nuts must go into the extrusion's grooves and the smooth rods in the smallest of the two front holes. | |
| [* 4] You must press down the ''z_tops'' until the smooth rod is touching on top of the hole. | |
| [* 9] This is very important! or it might affect the alignment of your X axis later. | |
| [* 5] Make sure the ''z_tops'' are parallel to the top of the extrusion | |
| [* 7] Tighten the 2x M5x10 screws. | |
| [* 9] Double check that the smooth rods are fully inserted in the ''z_tops''. |