Changes to Step #9

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Z tops installation
[* 8] Install the ''z_tops'' on top of the Z axis. T-nuts must go into the extrusion's grooves and the smooth rods in the smallest of the two front holes.
-[* 4] You must press down the ''z_tops'' until the smooth rod is touching on top of the hole.
+[* 4] You must press down the ''z_tops'' until the smooth rod is touching the top of the hole.
[* 9] This is very important as it might affect the alignment of your X axis later.
[* 5] Make sure the ''z_tops'' are parallel to the top of the extrusion
[* 7] Tighten the 2x M5x10 screws.
[* 9] Double check that the smooth rods are fully inserted in the ''z_tops''.