Changes to Step #10

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder installation
-[* 10] In this chapter you will have to follow external guides. As the Bear frame supports different extruders and X axis it would make this guide too long and hard to follow. Thank you for your comprehension :)
-[* 5] Reinstalll the extruder on the X axis by following the external guide(S) according to your extruder and X axis:
+[* 10] In this chapter you will have to follow external guides. As the Bear frame supports different extruders and X axes it would make this guide too long and complicated to follow. Thank you for your understanding :)
+[* 5] Reinstall the extruder on the X axis by following the external guide(s) relevant to the extruder and X axis of your choice:
[* 1] ***BearExxa*** (Bear extruder and X axis): start with [guide|36], then [guide|37] up to ***step 10*** and finish with [guide|38] up ***step 8***.
[* 1] ***BearMera*** (E3D Hemera): start with [guide|29] up to ***step 14***, and then [guide|31].
[* 1] ***Bondtech on Bear X axis***: follow [guide|40|our guide here].
[* 1] ***Original Prusa extruders*** installation guides: [https://help.prusa3d.com/en/guide/5-e-axis-assembly_28536|MK3S], [https://help.prusa3d.com/en/guide/3-e-axis-assembly_48816|MK2.5S], [https://help.prusa3d.com/en/guide/5-e-axis-assembly-spiral-wrap_68920|MK3 (spiral wrap)], [https://help.prusa3d.com/en/guide/5-e-axis-assembly-textile-sleeve_71288|MK3 (textile sleeve)], [https://prusa3d.dozuki.com/Guide/4.+E-axis+assembly+(spiral+wrap)/576?lang=en|MK2.5 (spiral wrap)], [https://prusa3d.dozuki.com/Guide/4.+E-axis+assembly+(textile+sleeve)/841?lang=en|MK2.5 (textile sleeve)], [https://help.prusa3d.com/en/guide/5-extruder-assembly_91416|MK2S].
[* 1] ***Bondtech extruder on original Prusa X axis***: choose the guide corresonding to your extruder on [https://support.bondtech.se/c/Prusa|support.bondtech.se/c/Prusa].