Changes to Step #10
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] Heated bed assembly - MK2(S) |
|---|---|
| + | [title] Heated bed assembly - MK2.5(S) |
| [* 9] Be careful with the extruder during this step, it will slide when you rotate the print to access screws under the heated bed. | |
| [* 8] Take 4x M3x8 bottom head head screws (reused from your Original Prusa) and secure the heated bed in the corner. Do not tighten the screws fully yet. | |
| [* 5] Using the 2x M3x12 screws, secure the ''y_belt_holder''. Do not tighten the screws fully yet. | |
| [* 1] Fully tighten all the screws ***incrementally*** in this precise orders (do not use excessive force or you might break the spacers): | |
| [* 4] 1st the screws of ''y_belt_holder''. | |
| [* 7] 2nd one of the corner in diagonal. | |
| [* 3] 3rd the other corner in diagonal. | |
| [* 1] Repeat until all screw are fully tighten. |