Changes to Step #10

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Heated bed assembly - MK2.5(S)
-[* 9] Be careful with the extruder during this step, it will slide when you rotate the print to access screws under the heated bed.
-[* 8] Take 4x M3x8 bottom head head screws (reused from your Original Prusa) and secure the heated bed in the corner. Do not tighten the screws fully yet.
-[* 5] Using the 2x M3x12 screws, secure the ''y_belt_holder''. Do not tighten the screws fully yet.
-[* 1] Fully tighten all the screws ***incrementally*** in this precise orders (do not use excessive force or you might break the spacers):
+[* 9] Be careful with the extruder during this step, it will slide when you rotate the printer to access screws under the heated bed.
+[* 8] Take 4x M3x8 button head screws (reused from your Original Prusa) and secure the heated bed in the corners. Do not fully tighten the screws yet.
+[* 5] Using the 2x M3x12 screws, secure the ''y_belt_holder'' to the bed. Do not fully tighten the screws yet.
+[* 1] Fully tighten all the screws ***evenly, incrementally and in turn***, in this precise orders (do not use excessive force or you might break the spacers):
[* 4] 1st the screws of ''y_belt_holder''.
[* 7] 2nd one of the corner in diagonal.
[* 3] 3rd the other corner in diagonal.
- [* 1] Repeat until all screw are fully tighten.
+ [* 1] Repeat until all screws are fully tightened.