Changes to Step #15

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 1] Prepare the following hardware:
[* 3] 9x M3x12 or M3x14 flat head screws (reused from your Original Prusa).
[* 7] 9x spacers 5.5x6x3 (reused from your Original Prusa).
- [* 5] 2mm Allen key
-[* 8] Move the bed to the front
+ [* 5] 1x 2mm Allen key.
+[* 8] Move the Y carriage to the front.
[* 4] Locate the center hole of the Y carriage.
-[* 6] Place a spacer on the hole of the Y carriage.
+[* 6] Place 1x spacer on the hole of the Y carriage.