Changes to Step #16

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[* 3] Insert the hex key in the center hole of the heated bed.
-[* 6] Place the heated bed with the hex key on the printer. Align the bed with the spacer and the center hole of the Y carriage using the hex key.
-[* 5] Add one of the M3 flat head screw and secure the bed in the center. To do tighten the screw completely yet.
+[* 3] Take your heated bed and insert the hex key in the centeral hole.
+[* 6] Place the heated bed with the hex key on the Y carriage. Align the bed with the spacer and the centeral hole of the Y carriage using the hex key.
+[* 5] Add one of the M3 flat head screw and secure the bed in the center. To do tighten the screw fully yet.