Changes to Step #7

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] PSU installation - Silver PSU
-[* 6] Rotate the frame to the right side. Be careful with the extruder, help him going down slowly.
-[* 8] Slide 2x t-nuts from the top of the frame.
-[* 5] Place the PSU and secure it with 2x M5x10 screws. Do not tighten fully yet.
+[* 6] Rotate the frame to the right side. Carefully guide the extruder to the right. Do not let it slide freely into the x-ends..
+[* 8] Slide 2x t-nuts into the extrusion from the top of the frame, as shown.
+[* 5] Position the PSU and secure it with 2x M5x10 screws. Do not tighten them fully yet.