Changes to Step #2
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| - | [* 1] Place a piece of paper on the heated to protect it |
| - | [* 1] Plug and turn on the printer |
| - | [* 6] Using the screen menu, move the X axis up until it crashes in the Z tops |
| + | [title] Trapezoidal nuts adjustment |
| + | [* 1] Place a piece of paper on the heated bed to protect it. |
| + | [* 1] Plug and turn on the printer. |
| + | [* 6] Using the screen menu, move the X axis up until it crashes in the Z tops. |
| [* 5] Turn the lead screws by hand to ensure both side are applying more even pressure to the Z tops. You might feel a step moving, on one side or both. | |
| - | [* 4] Move the Z axis down to approximately 10-15mm from the heated bed |
| + | [* 4] Move the Z axis down to approximately 10-15mm from the heated bed. |