Changes to Step #6

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] X smooth rods tension
[* 6] Adjust both M3x10 screws to have the ''x_end_idler'' parallel to the frame.
[* 2] Second image shows when the X axis is too short. In this case you need to tighten the two M3x10 screws.
[* 2] Third image shows when X axis is too long. In this case you need to unscrew the two M3x10 screws.
[* 9] It might happen that with excess tension on the M3x10 screws, the Z smooth rods will start to be off center on the Z tops. In this case release tension even if the ''x_end_idler'' is not totally parallel to the frame.
+[* 10] Check the next step if you have difficulty to see if the ''x_end_idler'' is parallel to the frame.