Changes to Step #7

Edit by Matthew Harrison —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] X smooth rods tension
[* 1] If you have difficulty to see if the ''x_end_idler'' is parallel to the frame you can use a thick ruler or a square like on the first image.
[* 5] Verify that your Z lead screw is not touching the Z tops holes. If it is touching release the pressure from the X smooth rods tensioning screws like explained in the previous step.
-[* 10] Note that Z lead screw does not need to be centered totally, it ca wobble a little.
+[* 10] Note that Z lead screw does not need to be centered totally, it can wobble a little.
[* 4] Double check that your belt is still well tensioned. In case it needs adjustment repeat the previous step.