Changes to Step #9
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Z calibration preparation | |
| [* 1] Turn on the printer. | |
| [* 1] Heat up the nozzle and insert PLA filament. Plain grey without sparkle is the best color for calibration. | |
| [* 4] Run Z calibration. | |
| [* 1] Because the extrusion multiplier and filament diameter are not calibrated yet, it will only give a first approximation of the first layer height. | |
| + | [* 9] If you have setup a different estep value in the past I recommend to reset it to its default. |