Changes to Step #10
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Print extruder calibration cube |
|---|---|
| + | [* 10] I recommend a micrometer instead of caliper for the following steps. Caliper are not precise enough to measure such small values and a micrometer has a ratchet system made to apply same pressure for all measures. |
| + | [* 1] Measure your filament diameter with a micrometer. Write it on a piece of paper. |
| + | [* 1] Download the calibration cube here : [https://www.thingiverse.com/thing:3405991|thingiverse.com/thing:3405991] |
| + | [* 3] Start Slic3r PE and load the calibration cube. On the main page, select the following parameters: |
| + | [* 1] Print settings: 0.20mm Normal |
| + | [* 1] Filament: Prusa PLA |
| + | [* 7] Report filament diameter to the filament settings. |
| + | [* 8] Reset "Extrusion multiplier" to 1mm. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added