Changes to Step #10
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Print extruder calibration cube | |
| [* 10] I recommend a micrometer instead of caliper for the following steps. Caliper are not precise enough to measure such small values and a micrometer has a ratchet system made to apply same pressure for all measures. | |
| [* 1] Measure your filament diameter with a micrometer. Write it on a piece of paper. | |
| [* 1] Download the calibration cube here : [https://www.thingiverse.com/thing:3405991|thingiverse.com/thing:3405991] | |
| [* 3] Start Slic3r PE and load the calibration cube. On the main page, select the following parameters: | |
| - | [* |
| - | [* |
| + | [* 3] Print settings: 0.20mm Normal |
| + | [* 3] Filament: Prusa PLA |
| [* 7] Report filament diameter to the filament settings. | |
| [* 8] Reset "Extrusion multiplier" to 1mm. |