Changes to Step #1

Edit by Michael Marbut —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Pinda adjustment
[* 6] Place a sheet of paper on your heated bed. Remove any residual filament going out of the nozzle.
[* 1] Ensure the hotend have cooled down and turn off the printer.
[* 2] Center your extruder on the X axis. Move it down by rotating simultaneously the Z lead screws. Go down until the nozzle is just touching the paper.
[* 7] Place the middle section of a zip tie under the Pinda.
[* 5] Release the M3x10 screw and gently press down the Pinda against the middle section of the zip tie.
-[* 5] Tighten the M3x0 screw.
+[* 5] Tighten the M3x10 screw.