Changes to Step #1
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [* 3] In the next steps we will install cable clips. You have to put them in the groove of an extrusion and rotate them 90° as shown on these images. | |
| [* 10] There are 3 different cables clips but they are all installed the same way. | |
| - | [* 10] Some images in this chapter are coming from the original Prusa assembly guide and are copyright of [https://www.prusa3d.com|Prusa Research] |
| + | [* 10] Some images in this chapter are coming from the original Prusa assembly guide and are copyright of [https://www.prusa3d.com|Prusa Research]. |