Changes to Step #1

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Cable clips installation
-[* 3] In the next steps we will install cable clips. You have to put them in the groove of an extrusion and rotate them 90° as shown on these images.
-[* 10] There are 3 different cables clips but they are all installed the same way.
-[* 10] Some images in this chapter are coming from the original Prusa assembly guide and are copyright of [https://www.prusa3d.com|Prusa Research] (steps 23, 28, 33 and 34).
+[* 3] In the next steps we will install cable clips. You have to put them in the groove of an extrusion and rotate them 90° as shown in these images.
+[* 10] There are 3 different types of cable clip but they are all installed in the same way.
+[* 10] Some images in this chapter are taken from the original Prusa assembly guide and are copyright of [https://www.prusa3d.com|Prusa Research] (steps 23, 28, 33 and 34).