Changes to Step #4

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 5] Install 1x ''cable_clip_vertical'' under the left Z motor at ***10mm*** from the joining plate.
[* 8] Install 1x ''cable_clip_horizontal'' spaced by ***25mm*** from the other side of the joining plate.
-[* 7] Repeat this step on the side of the right Z motor with the same distances.
+[* 7] Repeat this step under the other Z motor with the same distances.