Changes to Step #6
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [* 10] This step is for ***MK3(S) with silver PSU only***. | |
| [* 1] For Prusa MK2(S) or MK2.5(S) go to step xxx | |
| [* 1] For Prusa MK3(S) with black PSU go to the next step | |
| [* 8] Install 4x ''cable_clip_vertical'' on the back of the frame as following: | |
| [* 4] 35mm. | |
| [* 6] Equally separated. | |
| + | [* 1] Go to step xxx |