Changes to Step #6

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 10] This step is for ***MK3(S) with silver PSU only***.
- [* 1] For Prusa MK2(S) or MK2.5(S) go to step xxx
- [* 1] For Prusa MK3(S) with black PSU go to the next step
+ [* 1] For Prusa ***MK2(S) or MK2.5(S)*** go to [guide|50|step 5|stepid=622].
+ [* 1] For Prusa MK3(S) with ***black PSU*** go to the next step
[* 8] Install 4x ''cable_clip_vertical'' on the back of the frame as following:
[* 4] 35mm.
[* 6] Equally separated.
-[* 1] Go to step xxx
+[* 1] Go to [guide|50|step 8|stepid=626].