Changes to Step #7
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 10] This step is for ***MK3(S) with black PSU only***. |
|---|---|
| + | [* 1] For Prusa MK2(S) or MK2.5(S) go to step xxx |
| + | [* 1] For Prusa MK3(S) with silver PSU go to step xxx |
| + | [* 8] Install 4x ''cable_clip_vertical'' on the back of the frame as following: |
| + | [* 4] Separated by 35mm. |
| + | [* 6] Equally separated. |
Image 1
No previous image
Added
Image 2
No previous image
Added