Changes to Step #11

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[* 10] Different board same assembly
-[* 4] remove M3x10
-[* 5] Remove the nuts with another screw
+[* 10] In this step we are showing an RAMBo Einsy board (MK3(S)) but the step is the same with RAMBo Mini board (MK2(S) and MK2.5S(S)).
+[* 4] Remove the two M3x10 screws from the left side of the board.
+[* 5] Remove the 2x hex nuts from the back of the electronic cover. You can engage a screw on the nuts and pull them out.