Changes to Step #11
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Electronic cover base installation |
|---|---|
| [* 10] In this step we are showing an RAMBo Einsy board (MK3(S)) but the step is the same with RAMBo Mini board (MK2(S) and MK2.5S(S)). | |
| [* 4] Remove the two M3x10 screws from the left side of the board. | |
| [* 5] Remove the 2x hex nuts from the back of the electronic cover. You can engage a screw on the nuts and pull them out. |