Changes to Step #11

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Electronic cover base installation
-[* 10] In this step we are showing an RAMBo Einsy board (MK3(S)) but the step is the same with RAMBo Mini board (MK2(S) and MK2.5S(S)).
+[* 10] In this step we are showing a RAMBo Einsy board (MK3(S)) but the step is the same for the RAMBo Mini board (MK2(S) and MK2.5S(S)).
[* 4] Remove the two M3x10 screws from the left side of the board.
-[* 5] Remove the 2x hex nuts from the back of the electronic cover. You can engage a screw on the nuts and pull them out.
+[* 5] Remove the 2x hex nuts from the back of the electronic cover. You can thread a screw into the nuts to pull them out.