Changes to Step #8

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Electronic cover base installation
-[* 7] Take the ''rambo_base_lower_mount'' and insert an M3x10 scew with a ***washer*** in the smallest hole.
+[* 7] Take the ''rambo_base_lower_mount'' and insert an M3x10 scew with a ***washer*** through the smallest hole.
[* 3] From the other side, thread on an M3 hex nut and tighten the screw until the nut is fully seated in the part .
[* 5] Remove the screw and washer.