Changes to Step #10

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Electronic cover base installation
[* 8] Take the ''rambo_base_upper_mount''.
-[* 5] Insert an M3 hex nut using the same technique as with the ''rambo_base_lower_mount''.
-[* 3] Insert 1x M5x8 screw in the rambo_base_upper_mount.
-[* 7] Engage 1x t-nuts on the M5 screw (1-2 turns) and place it vertically.
+[* 5] Insert an M3 hex nut, into the part, using the same technique used for the ''rambo_base_lower_mount''.
+[* 3] Insert 1x M5x8 screw into the rambo_base_upper_mount.
+[* 7] Thread 1x t-nut onto the M5 screw (1-2 turns) and orient it vertically.