Changes to Step #9
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [* 1] 1x M5x8, 1x t-nut |
|---|---|
| + | [* 3] Insert 1x M5x8 screw in the ''rambo_base_lower_mount''. |
| + | [* 7] Engage 1x t-nuts on the M5 screws (1-2 turns) and place it vertically. |
| + | [* 5] Slide the ''rambo_base_lower_mount'' on the external side of the extrusion (X motor side) down to the joining plate. Make sure the ''rambo_base_lower_mount'' is flushed with the jplate and tighten the M5 screw fully. |