Changes to Step #9

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Electronic cover base installation
-[* 3] Insert 1x M5x8 screw in the ''rambo_base_lower_mount''.
-[* 7] Engage 1x t-nuts on the M5 screw (1-2 turns) and place it vertically.
-[* 5] Slide the ''rambo_base_lower_mount'' on the external side of the extrusion (X motor side) down to the joining plate. Make sure the ''rambo_base_lower_mount'' is flushed with the jplate and tighten the M5 screw fully.
+[* 3] Insert 1x M5x8 screw into the ''rambo_base_lower_mount''.
+[* 7] Thread 1x t-nut onto the M5 screw (1-2 turns) and orient it vertically.
+[* 5] Slide the ''rambo_base_lower_mount'' into the outside channel of the extrusion (X motor side) and down to the joining plate. Make sure that the ''rambo_base_lower_mount'' is flush with the joining plate, then fully tighten the M5 screw.