Changes to Step #12
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 3] Take the X axis motor and plug it in the top left connector (4 pins). |
|---|---|
| + | [* 10] This is the same connector for MK2(S), MK2.5(S) and MK3(S). |
| + | [* 7] Push the textile sleeve with cables in the hexagon hole (keep some slack to the cable to not force on the connector). |
| + | [* 8] Insert 2x M3x14 screws. Be careful to not loose them. |
| + | [* 5] Place the electronic cover on the ''rambo_base_lower_mount'' and tighten the bottom M3x14 from the inside of the cover. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added