Changes to Step #12

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 3] Take the X axis motor and plug it in the top left connector (4 pins).
[* 10] This is the same connector for MK2(S), MK2.5(S) and MK3(S).
-[* 7] Push the textile sleeve with cables in the hexagon hole (keep some slack to the cable to not force on the connector).
+[* 7] Push the textile sleeve with cables in the hexagon hole (keep some slack with the cable to not force on the connector).
[* 8] Insert 2x M3x14 screws. Be careful to not loose them.
[* 5] Place the electronic cover on the ''rambo_base_lower_mount'' and fully tighten the bottom M3x14 from the inside of the cover.