Changes to Step #12

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Electronic cover base installation
-[* 3] Take the X axis motor and plug it in the top left connector (4 pins).
- [* 10] This is the same connector for MK2(S), MK2.5(S) and MK3(S).
-[* 7] Push the textile sleeve with cables in the hexagon hole (keep some slack with the cable to not force on the connector).
-[* 8] Insert 2x M3x14 screws. Be careful to not loose them.
-[* 5] Place the electronic cover on the ''rambo_base_lower_mount'' and fully tighten the bottom M3x14 from the inside of the cover.
+[* 3] Take the X axis motor and plug it into the top left connector (X motor) (4 pins).
+ [* 10] This is the same for the MK2(S), MK2.5(S) and MK3(S).
+[* 7] Push the textile sleeve and cable into the hexagonal hole, as shown. Allow some slack in the cable, so as not to put any strain on the connector.
+[* 8] Insert 2x M3x14 screws. Take care that they do not fall out while you are attaching the cover to the mounts.
+[* 5] Attach the electronic cover to the ''rambo_base_lower_mount'' by fully tightening the lower M3x14 screw.