Changes to Step #12
Edit by Dave Ogles —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| + | [title] Electronics cover base installation |
| [* 3] Take the X axis motor and plug it into the top left connector (X motor) (4 pins). | |
| [* 10] This is the same for the MK2(S), MK2.5(S) and MK3(S). | |
| [* 7] Push the textile sleeve and cable into the hexagonal hole, as shown. Allow some slack in the cable, so as not to put any strain on the connector. | |
| [* 8] Insert 2x M3x14 screws. Take care that they do not fall out while you are attaching the cover to the mounts. | |
| - | [* 5] Attach the |
| + | [* 5] Attach the electronics cover to the ''rambo_base_lower_mount'' by fully tightening the lower M3x14 screw. |