Changes to Step #13

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 5] Slide the ''rambo_base_upper_mount'' from the top of the Z axis.
-[* 8] Align the ''rambo_base_upper_mount'' on the electronic cover and fully tighten the bottom M3x14 from the inside of the cover.
-[* 7] Fully tighten the M5x8 screw.
+[* 8] Align the ''rambo_base_upper_mount'' on the electronic cover and fully tighten the top M3x14 from the inside of the cover.
+[* 7] Tighten the M5x8 screw fully.