Changes to Step #13

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[title] Electronic cover base installation
-[* 5] Slide the ''rambo_base_upper_mount'' from the top of the Z axis.
-[* 8] Align the ''rambo_base_upper_mount'' on the electronic cover and fully tighten the top M3x14 from the inside of the cover.
-[* 7] Tighten the M5x8 screw fully.
+[title] Electronics cover base installation
+[* 5] Slide the ''rambo_base_upper_mount'' into the outside channel of the extrusion (X motor side).
+[* 8] Align the ''rambo_base_upper_mount'' with the upper mounting point of the electronics cover and fully tighten the M3x14 screw.
+[* 7] Fully tighten the M5x8 screw.