Changes to Step #13

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Electronics cover base installation
[* 5] Slide the ''rambo_base_upper_mount'' into the outside channel of the extrusion (X motor side).
-[* 8] Align the ''rambo_base_upper_mount'' with the upper mounting point of the electronics cover and fully tighten the M3x14 screw.
+[* 8] Align the ''rambo_base_upper_mount'' with the mounting point of the electronics cover and fully tighten the upper M3x14 screw.
[* 7] Fully tighten the M5x8 screw.