Changes to Step #15

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Z and Y motors wiring
-[* 7] Attach the other Z stepper wire to the zip tie as shown in this picture.
-[* 4] Plug Y axis motor on the RAMBo Mini/Einsy.
-[* 8] Plug the ***two*** Z motors on the RAMBo Mini/Einsy.
-[* 9] Verify the connections are correctly plugged.
+[* 7] Attach the right Z motor wire to the ''cable_clip_vertical'', with a zip tie, as shown.
+[* 4] Plug the Y axis motor into the correct connector on RAMBo Mini/Einsy board, as shown.
+[* 8] Plug the ***two*** Z motors into correct connectors on the RAMBo Mini/Einsy board, as shown. The order, (Left or Right) that the Z motors are plugged into the board, does not matter.
+[* 9] Verify that the connections are fully inserted and are plugged into the correct connectors.