Changes to this Step
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Back cables routing - MK2(S)/MK2.5(S) |
|---|---|
| [* 11] Direct links to the original Prusa electronic assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://prusa3d.dozuki.com/Guide/6.+Electronics/573?lang=en|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S] | |
| [* 1] Gather the cables from the PSU, Y motor, the Y end stop and the Z motor from the PSU side (do not take the Z motor cable from the X motor side). | |
| [* 7] Create a S with the Y end stop cable to avoid tension. | |
| [* 5] Add zip ties to group the cables as shown on the image. Do not tighten the zip ties yet as you might need to readjust the position of some cables later. | |
| [* 8] Gather the PSU cables and the Z motor cable together. Attach them with a zip tie to the ''cable_clip_horizontal''. Tighten the zip tie until it is snug but do no over-tighten or you might damage the wires. | |
| [* 4] The Y axis cables of MK2(S) or MK2.5(S) is a little too long. To help with the wiring you can create a small loop with the extra length. Tighten the Y motor, Z motor and PSU cables together with as zip tie. | |
| [* 9] Make sure no wire is under tension. Do not over-tighten the zip ties or you might damage the wires. |