Changes to Step #19
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 10] Direct links to the original Prusa assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://help.prusa3d.com/en/guide/introduction_132216|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S] |
|---|---|
| [* 1] Plug the following connectors: | |
| [* 7] X end stop | |
| [* 8] Y end stop | |
| [* 3] 12V from the PSU (order does not matters) | |
| [* 9] Check that all connectors are properly plugged in and no wire is under tension or pinched! |