Changes to Step #19

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[* 10] Direct links to the original Prusa assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://help.prusa3d.com/en/guide/introduction_132216|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S]
+[* 10] Direct links to the original Prusa assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://prusa3d.dozuki.com/Guide/6.+Electronics/573?lang=en|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S]
[* 1] Plug the following connectors:
[* 7] X end stop
[* 8] Y end stop
[* 3] 12V from the PSU (order does not matters)
[* 9] Check that all connectors are properly plugged in and no wire is under tension or pinched!