Changes to Step #20

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Heated bed wiring - MK2(S)/MK2.5(S)
[* 11] Direct links to the original Prusa electronics assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://prusa3d.dozuki.com/Guide/6.+Electronics/573?lang=en|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S]
-[* 5] Attach the heated bed textile sleeve (or spiral wrap).
+[* 5] Insert the heated bed wiring and textile sleeve (or spiral wrap) through the right of the electronics cover. Secure them with the printed part and 2x M3x10 screws.
[* 10] The image is showing the electronic cover for MK2.5(S), the MK2(S) version is slightly different. Refer to the Prusa guide if necessary.
[* 1] Plug the following connectors:
[* 4] Heated bed thermistor.
[* 2] Heated bed heater.
[* 9] Check that all connectors are properly plugged in and no wire is under tension or pinched!