Changes to Step #22
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [* 11] Direct links to the original Prusa electronic assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://prusa3d.dozuki.com/Guide/6.+Electronics/573?lang=en|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S] | |
| [* 7] Attach the extruder textile sleeve (or spiral wrap) to the top of the electronic cover. | |
| - | [* 10] The image is showing the electronic cover for MK2.5(S), the MK2(S) version is slightly different. |
| + | [* 10] The image is showing the electronic cover for MK2.5(S), the MK2(S) version is slightly different. Refer to the Prusa guide if necessary. |
| [* 1] Plug the following connectors: | |
| [* 4] Extruder motor | |
| [* 3] Extruder heater | |
| [* 9] Check that all connectors are properly plugged in and no wire is under tension or pinched! |