Changes to Step #23
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 11] Direct links to the original Prusa assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://prusa3d.dozuki.com/Guide/6.+Electronics/573?lang=en|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S] |
|---|---|
| + | [* 10] We are now going to connect the PINDA, left hotend fan and filament sensor. This steps is a little different between MK2(S) and MK2.5(S). 1st image shows MK2(S) connections and 2nd image shows MK2.5(S) connections (via adapters). |
| + | [* 1] Plug the following connectors: |
| + | [* 7] PINDA probe |
| + | [* 8] Left hotend fan |
| + | [* 6] MK2.5(S) Filament sensor. Use the lower row and ensure the red wire is oriented toward the back of the printer (check the 3rd image). |
| + | [* 10] 3rd image copyright: [https://www.prusa3d.com|Prusa Research] |
| + | [* 9] Check that all connectors are properly plugged in and no wire is under tension or pinched! |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added