Changes to Step #23

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder wiring - MK2(S)/MK2.5(S)
-[* 11] Direct links to the original Prusa electronic assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://prusa3d.dozuki.com/Guide/6.+Electronics/573?lang=en|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S]
+[* 11] Direct links to the original Prusa electronics assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://prusa3d.dozuki.com/Guide/6.+Electronics/573?lang=en|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S]
[* 10] We are now going to connect the PINDA, left hotend fan and filament sensor. This steps is slightly different for the MK2(S) and the MK2.5(S). The ***1st image shows MK2(S)*** connections and the ***2nd and 3rd images show MK2.5(S)*** connections (via adapters).
[* 1] Plug the following connectors:
[* 7] PINDA probe
[* 8] Left hotend fan
[* 6] Filament sensor for ***MK2.5(S) only***. Use the lower row and ensure the red wire is oriented toward the back of the printer (check the 3rd image).
[* 9] Check that all connectors are properly plugged in and no wire is under tension or pinched!