Changes to Step #24
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 11] Direct links to the original Prusa assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://prusa3d.dozuki.com/Guide/6.+Electronics/573?lang=en|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S] |
|---|---|
| + | [* 1] Plug the following connectors: |
| + | [* 4] Extruder thermistor (has yellow and green heat shrink). |
| + | [* 8] Front extruder fan (has a red heat shrink) |
| + | [* 7] LCD cable with ***TWO*** stripes (named EXP2 on the LCD board) |
| + | [* 2] LCD cable with ***ONE*** stripe (named EXP1 on the LCD board) |
| + | [* 5] Check the orientation of the LCD cables. The ergot should match the white drawing on the RAMBo Mini board. |
| + | [* 9] Check that all connectors are properly plugged in and no wire is under tension or pinched! |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added