Changes to Step #24

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder and LCD wiring - MK2(S)/MK2.5(S)
-[* 11] Direct links to the original Prusa electronic assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://prusa3d.dozuki.com/Guide/6.+Electronics/573?lang=en|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S]
+[* 11] Direct links to the original Prusa electronics assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://prusa3d.dozuki.com/Guide/6.+Electronics/573?lang=en|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S]
[* 1] Plug the following connectors:
[* 4] Extruder thermistor (has yellow and green heat shrink).
[* 8] Front extruder fan (has a red heat shrink)
[* 7] LCD cable with ***TWO*** stripes (named EXP2 on the LCD board)
[* 2] LCD cable with ***ONE*** stripe (named EXP1 on the LCD board)
[* 5] Check the orientation of the LCD cables. The locator tab, on the connector, should match the white drawing on the RAMBo Mini board. Typically this means that the red stripe on the ribbon cable is towards the top of the board, as shown.
[* 9] Check that all connectors are properly plugged in and no wire is under tension or pinched!