09. Electronics assembly Step #27 History

Changes to Step #27

Edit by Grégoire Saunier — Jul 27, 2020

	[* 11] Direct links to the original Prusa assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648\|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136\|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416\|MK3S].
	[* 9] For the whole wiring process: make sure no wire is under tension and do not over-tighten the zip ties.
	[* 7] Gather the cables from the PSU (including Power Panic), the Y motor, and the Z motor (from the PSU side).
-	[* 5] Add zip ties to group the cables as shown on the image. *Do not fully tighten the zip ties yet* as you might need to readjust the position of some cables ~~later~~.
+	[* 5] Add zip ties to group the cables as shown on the image. *Do not fully tighten the zip ties yet* as you might need to readjust the position of some cables in the next steps.

	[* 11] Direct links to the original Prusa assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648\|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136\|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416\|MK3S].
	[* 9] For the whole wiring process: make sure no wire is under tension and do not over-tighten the zip ties.
	[* 7] Gather the cables from the PSU (including Power Panic), the Y motor, and the Z motor (from the PSU side).
-	[* 5] Add zip ties to group the cables as shown on the image. *Do not fully tighten the zip ties yet* as you might need to readjust the position of some cables ~~later~~.
+	[* 5] Add zip ties to group the cables as shown on the image. *Do not fully tighten the zip ties yet* as you might need to readjust the position of some cables in the next steps.