Changes to Step #27

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[title] Back cables routing - MK3(S)
-[* 11] Direct links to the original Prusa electronic assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S].
+[title] Rear cable routing - MK3(S)
+[* 11] Direct links to the original Prusa electronics assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S].
[* 7] Gather the cables from the PSU (including Power Panic), the Y motor, and the Z motor from the PSU side (do not take the Z motor cable from the X motor side).
[* 5] Add zip ties to group the cables as shown on the image. ***Do not fully tighten the zip ties yet*** as you might need to readjust the position of some cables in the next steps.
[* 9] Verify that no wire is under tension.